S30 Stainless Co2 Pressure Top Up Valve With Piercing Pin
S30 Stainless Co2 Pressure Top Up Valve With Piercing Pin
£15.42
Ex Tax: £15.42
- Stock: 102 In Stock
- Genuine S30 Stainless Steel Co2 Pressure Top Up Valve With Piercing Pin.
- Compatible With 8 Gram Co2 Bulbs & Incorporates A Safety Release Valve.
- Please Note This Genuine S30 Valve Has A Floating Piercing Pin (Compatible With 8g Bulbs) Which Can Be Removed If Required & Then Becomes Compatible With The Larger S30 And L30 Co2 Cylinders.
Tonys Tips
These Stainless Steel S30 Pressure Top Up Valves with pressure release come as Standard shown here, with Piercing Pin for use with the 8 gram CO2 Bulbs. I must say, I now find the Bulb Top Up System more beneficial than the S30 Large CO2 Cylinder used without Floating piercing pin, as replacement bulbs are more easily and economically sent by mail order and the barrel requires less headroom for recharging.
Fitting the Valve in 2" or 4" caps
These S30 valves are well made in shiny stainless steel and are a good deal stronger than the plastic Barrel Caps in which they are inserted and fixed.
It is therefore necessary to use TWO Spanners to tighten the securing nut so as not to depend on the flat sided hole in the soft plastic cap to prevent rotation of the valve as the nut is tightened.
To do this without shearing the cap hole and causing leakage, hold the larger spanner on the securing nut while the smaller spanner holds still the straight sided threaded shaft of the S30 valve above. Now gently tighten the nut so that the rubber washer is in firm contact with the cap and valve flange inside the cap.
Be careful not to over-tighten the valve as the rubber washer may be distorted and dragged out of shape risking leakage.
These Stainless Steel S30 Pressure Top Up Valves with pressure release come as Standard shown here, with Piercing Pin for use with the 8 gram CO2 Bulbs. I must say, I now find the Bulb Top Up System more beneficial than the S30 Large CO2 Cylinder used without Floating piercing pin, as replacement bulbs are more easily and economically sent by mail order and the barrel requires less headroom for recharging.
Fitting the Valve in 2" or 4" caps
These S30 valves are well made in shiny stainless steel and are a good deal stronger than the plastic Barrel Caps in which they are inserted and fixed.
It is therefore necessary to use TWO Spanners to tighten the securing nut so as not to depend on the flat sided hole in the soft plastic cap to prevent rotation of the valve as the nut is tightened.
To do this without shearing the cap hole and causing leakage, hold the larger spanner on the securing nut while the smaller spanner holds still the straight sided threaded shaft of the S30 valve above. Now gently tighten the nut so that the rubber washer is in firm contact with the cap and valve flange inside the cap.
Be careful not to over-tighten the valve as the rubber washer may be distorted and dragged out of shape risking leakage.